Well after the failure of my home-made mould. I popped over to Barnes in Richmond (it’s near work) and picked up some Pinkysil, Epoxyglass and Bright orange translucent pigment. This made for a much easier (and way less sticky) moulding process.
First time moulding came out okay.
If this is your first visit, check out Blade Runner (PKD) Blaster – Part 1.
I got rid of the air-dry clay and replaced it with Apoxie Sculpt.
How did I not know about this stuff before?
Apoxie Sculpt FTW! Continue reading Blade Runner (PKD) Blaster – Part 5
I’ve been playing around with some air-dry clay to get the cylinder going. Using hollowed out and cleaned AA batteries as the shells.
Hindsight is 20/20
Just realised I could have done everything I planned without splitting it in half.
As my daughter says “I don’t matter and it doesn’t mind”
Had a little bit of fun this afternoon…
I managed to grab one of the Elfin Knights Takagi Type M2019 WaterBlasters from Japan before they became hard to get.
After reading the Cheap PKD (Water Gun) thread on the RPF (for the third time) I started work.